Electronics

Description:The ESP-C3-12F-Kit development board is a core development board designed by ESP-C3-12F for the ESP-C3-12F module. The development board continues the classic design of the NodeMCU development board, leading all I/O to the With pin headers, developers can connect peripherals according to..

Package includes:1 x ESP32 0.96 OLED 1 x HX711 Module 1 x 1KG Weight Sensor 2 x Bracket 1 x Cable 1 x Screws (bag)Wiring:..

Note: OLED is not soldered to T-BEAMIf you need additional OLED, you can buy it Contact Us Product Upgrade Content: 1. Pin GPIO34 pin is replaced with GPIO35 2. Replace the charging IC (TP5400) with the power management AXP192 3. GPS TX, RX pin replacement 4. ..

Feature:ESP32-C3 is a low-cost microcontroller from Espressif that supports 2.4 GHz Wi-Fi and Bluetooth® Low Energy ( Bluetooth 5 (LE)).Use RISC V as the core.There's a minimum number of pins on this chip, it's specifically designed to be low cost and for simpler projects than ESP32-Sx or ESP32 clas..

What is C3FH4 RGB? C3FH4 RGB features an ultra-compact design with one risc-v 32-bit single core processor at 160MHz on a PCB, built-in 400 KB SRAM and 4 MB Flash , integrated with 2.4 GHz Wi Fi and supporting long-distance Bluetooth 5 (LE), with industry-leading RF performance and low power consump..

Features:Use low-power dual-core 32-bit CPU, which can be used as an application processor.The main frequency is up to 240MHz, and the computing power is up to 600 DMIPSBuilt-in 520 KB SRAM, external 8MB PSRAMSupport UART/SPI/I2C/PWM/ADC/DAC and other interfacesSupport OV2640 and OV7670 cameras, bui..

ESP32 Development Board WiFi+bluetooth Ultra Low Power Consumption Dual Cores ESP-32 ESP-32S Board for Arduino - products that work with official Arduino boardsIntroduction:   ESP32 is already integrated antenna and RF balun, power amplifier, low-noise amplifiers, filters,  and power ma..

Feature:This is a DIY product and needs to be soldered by yourself.Package includes:1 x DIY kit..

ESP32 ESP32S 18650 Battery Charge Shield V3 Micro USB Type-A USB 0.5A Test Charging Protection Board for Arduino - products that work with official Arduino boardsNote:   This module is suitable for 18650 battery only This module can be powered or for raspberry pi and sensor at ..

Description:PoESP32 Unit is an ESP32 Ethernet Unit supports PoE (Power Over Ethernet). This module adopts ESP32 as built-in MACs, and IP101G as physical layer transceiver. Default firmware with ESP-AT, supports TCP,MQTT, HTTP protocols. It can connect to server with simple AT commands through serial..

Description:The ESP32-CAM-MB module is a small camera module with a size of 39.8*27*16.2mm. This module can work independently as the smallest system. A brand-new WiFi+Bluetooth dual-mode development board is based on the ESP32 design, uses PCB onboard antennas, is equipped with two high-performance..

>>>Manual: Contact Us<<<Note: This product has built-in antenna,if you need to use external antenna, you should resoldering resistance with soldering iron by yourself.Step 1: To weld this two parts in blue boxStep 2: To Fuse the two position selected by the green boxes in..