Features:✔ Divided into A and B sides✔ Separate bending mode.✔ Support installation on hot bed, glass platform.✔ The printing is not warped, and no glue is needed for use.✔ PC material. Long-term temperature resistance within 130℃. 130-180℃ will weaken the magnetism but will not lose the magnetism...
Features:✔ Divided into A and B sides✔ Separate bending mode.✔ Support installation on hot bed, glass platform.✔ The printing is not warped, and no glue is needed for use.✔ PC material. Long-term temperature resistance within 130℃. 130-180℃ will weaken the magnetism but will not lose the magnetism...
Features:1. 200*3mm, for most of 3D printer model, can work at 300℃ for a long time
2. Smooth surface, good thermal shock resistance
3. Enable to make the inner temperature change gently while saving the power supply
4. With high temperature adhesive tape for connecting to heated bed, reduce the h..
#A = 2020 Aluminum Profile Version#B = 2040 Aluminum Profile VersionParameters:Product name:2020/2040 aluminum profile line rail fixed blockApplication : Applicable MGN12 linear guideSurface treatment: anodic oxidation Note: The following data are manual measurements, there will be errors!..
Introduction: Post-curing lamp for 3D printer. Say goodbye to several kilowatts of power consumption, farewell to several hundred degrees of high temperature, farewell to hundreds of hours or even tens of hours of life, farewell to several minutes of warm-up time. About curing effect: To..
Features:
1. Power module for controlling 3D printer heated bed
2. Handle high current but without being heat at the same time
3. Powerful MOSFET HA210NO6
4. Allow PID control of the heated bed (DC-DC Relays usually do not allow this)
5. Safe for prolonged times without active cooling.
6. Ca..
Features:✔ Divided into A and B sides✔ Separate bending mode.✔ Support installation on hot bed, glass platform.✔ The printing is not warped, and no glue is needed for use.✔ PC material. Long-term temperature resistance within 130℃. 130-180℃ will weaken the magnetism but will not lose the magnetism...
Features:
1. Anti-vibration, anti-shake, anti-friction of hot bed, strong adsorption force;
2. With stability, stability and durability.
3. Easy to replace, high temperature resistance, good electrical insulation performance, its dielectric loss, voltage resistance, arc resista..
Features:✔ Divided into A and B sides✔ Separate bending mode.✔ Support installation on hot bed, glass platform.✔ The printing is not warped, and no glue is needed for use.✔ PC material. Long-term temperature resistance within 130℃. 130-180℃ will weaken the magnetism but will not lose the magnetism...