10pcs Self-adhesive Marble Pattern Wall Sticker Waterproof Kitchen Bathroom Decoration

-No grout, no glue, no special tool and no mess.
It can be installed in minutes over a clean, dry, flat, and smooth surface.
-Resistant to the heat of stovetops and humidity of bathrooms.
-3D effect, virtually indistinguishable from real tiles.
-Resistant to stain, fading, moisture and mildew.
-Sticked very firmly and avoid the piece go off.
-Easy to install, maintain and clean.

Materials:PET+PU+glue
Size:30.5x30.5cm/12x12in

Step 1: First determine the location where you want to install the wall sticker, and then clean the wall to make it clean and tidy. Please do not post if you are painting a new wall or damp wall, and wait for it to dry before posting.
Step 2: Please find the reference line when installing the first wall sticker, and make sure to align with the horizontal line, so as to facilitate the installation of the remaining parts. Please be patient, the more perfect you post the better. When you want to remove the wall sticker from the backing paper, lift it up from its four corners. Attach the part exposed to water to the wall. At the same time, hold down the part that has been glued, continue to slowly remove the remaining backing paper, while peeling and pressing the wall sticker at the same time, until the whole piece of backing paper comes off, the first piece is installed
Step 3: For the second wall sticker and the remaining products, the overlapping installation of the edges should be based on the interface of the previous one. Each wall sticker has its own corresponding interface, and after each installation, an interface will be left to overlap and dock the next wall sticker. The product cannot be installed directly without the correct interface.
Step 4: The wall sticker cannot be folded when it meets the corner of the wall or when it is connected from one side of the wall to the other. Please measure the distance between the last piece of wall sticker and the corner and cut out the appropriate size for installation.
Step 5: Use a sharp  to cut through the ruler. At the overlapping interface, vigorous pressure can be applied for installation. When installing against the corner, it also needs to be pressed hard.
Step 6: One more important feature, transferable performance: After the sticker is attached to the glass or a flat surface, when the surface is peeled off again, there is no glue remaining on the surface or the glue is damaged; and the sticker can be effectively pasted again. However, if there is no special reason, do not paste repeatedly to avoid affecting the effect of wall stickers.

-Please allow a bit error due to manual measurement. please make sure you do not mind before you bid.
-The color may have different as the difference display, please understand.

10 x Wall Sticker