- Stock: In Stock
- Model: ST230043217
- SKU: ST230043217
Feature:
1. FT245RL
USB independent chip for parallel FIFO bidirectional data transmission interface
Complete USB protocol processing chip-no specific USB firmware programming required
Based on 4-wire handshake connection, simple interface for MCU/PLD/FPGA logic
Data transfer rate up to 1 Megabyte/second-D2XX Direct Drivers
Data transfer rate up to 300kilobyte/second-VCP Drivers
256-byte receive buffer and 128-byte send buffer, using buffer smoothing technology to achieve high data throughput
2. USB interface
Provide two types of mini USB and type A USB interfaces to choose from
3. VCCIO power supply jumper
The jumper cap can be used to jump to VCCIO to access 5V or 3.3V voltage (VCCIO can be used to supply power to the VCC pin of the access board)
4. Power indicator
Module power indicator, easy to check the power supply status of the module
5. Interface
Connect to the corresponding interface of the single chip microcomputer
| PIN Name | Type | Description |
| VCCIO | Power supply | It can be used to supply the FT245 chip or power to external devices, and can be set to 3.3V or 5V through the VCCIO jumper |
| GND | Power supply | Power ground |
| D0~D7 | Input Output | FIFO data bus bits 0~7 |
| NC | NC | Dangling |
| RST# | Input | Used to reset FT245 |
| PWREN# | Output | After the USB configuration is successful, it is set low, and is pulled high when the USB is terminated |
| TXF# | Output | Does not write to FIFO when pulled high, data can be written to FIFO when TXF# is pulled low, and WR# is pulled high |
| RXF# | Output | Does not read FIFO when pulled high, when RXF# is pulled low, and RD# is pulled low, valid data of FIFO can be read |
| WR# | Input | Write to FIFO when pulled low |
| RD# | Input | Read FIFO when pulled low |
Package includes:
1 x FT245 USB FIFO Board
