4Pcs RGB 16 Colors Round Cabinet Lights Remote Control 1000MAH USB Rechargeable

Specification:

Voltage: 3.7V

Power: 0.3W 

Maximum Lumen: 30LM

Warm Light Color Temperature: 4000K

Lamp Bead Model: SMD 2835/5050

Number of Lamp Beads: 3+3, a total of 6 lamp beads

Shell Material: ABS + PC

Power Supply: Micro USB

Control Mode: Touch Control + Infrared Remote Control

Remote Control Distance: Within 5 meters (for Micro USB)

Lithium Battery Capacity: 1000MA 

Lighting Time: 100% brightness, can be lit for 12 to 14 hours/ 50% initial brightness, can be bright for about 25 hours

Charging Time: 2H

RGB Light Color: 16 Colors

Timing: 3 Types, 30 minutes, 60 minutes, 120 minutes



Functions:

1. Press the lampshade above the lamp body, the first press is warm light, the second press is red light, the third press is green light, the fourth press is blue light, and the fifth press is dynamic mode 1 (slow transition mode) ), the 6th press is dynamic mode 2 (fast jump mode), the 7th press is dynamic mode 3 (non-polar mode), and the 8th press is off.

2. Long press to adjust the brightness (Note: Mode 3 can not adjust the brightness)

3. You can use the remote control to control 16 kinds of colors you want to use constantly.

4. You can set the timer function to turn off the light. Use the time button on the remote control to set the time. First, the timing time is 30 minutes, 60 minutes, 120 minutes, the light flashes for entering the timing. Timing function can be used in static mode and dynamic mode.

5. This product uses Micro USB for charging, the red light is the charging state, and the green light is the full state.



Installation:

1. We provide double-sided tape for each lamp. All you need to do is stick one side of the tape to the rotating cover at the bottom of the lamp, and then stick the other side to the surface you want to stick. (Includes adhesive)

2. Before pasting, clean the pasting position and the bottom cover of the surface light with a cleaning cloth to maximize the viscosity.

3. There are 2 screw holes in the rotating cover at the bottom of the lamp body, which can be fixed with screws. (Screw not included)

4. If the battery is exhausted, turn the top of the lamp counterclockwise to remove it, and then replace it when fully charged to use.



Note: 

1. When closing the bottom cover, stick it to the location pasting point;

2. Do not soak in water and disassemble at will;

3. CR2025 button battery is included in the remote control. During the transportation, we added a transparent PVC insulation board between the batteries. When you use the remote control for the first time, you need to pull out the insulation sheet to use it.

5. The distance of the remote control depends on the power and direction. The light receivers are on the left and right sides of the Micro USB. The remote control needs to be aligned to be flexibly controlled. If the power is sufficient, you can control it at 5 meters. If the remote control does not work properly, remove the lamp body to charge it.

6. This product has no memory function, and it will be restored to the factory settings every time it is turned off and then turned on again.

7. With an independent switch at the bottom. Please turn off the switch if you are not using it for a long time to prevent power consumption.



Package Included:

4 x Cabinet Light

1 x Remote Control

1 x USB Cable

4 x Adhesive

1 x Manual